To configure a MS SNA Server connection

Start a new session, and select Microsoft SNA Server as your connection type.

Table 4

Do this	To
Choose the Add button	Add a new Microsoft SNA Server connection type.
Select a connection type from the list and choose the Edit button	Edit a connection.
Select a connection type from the list and choose the Delete button	Delete a connection.
Select a connection type from the list and choose the Copy button	Copy a connection type to the Clipboard.
Choose the Paste button	Paste the copied connection into the list.

Select Enable Infinite List Retries if you want Extra! to go through the list of configured connections again and again until a successful connection is made.
From the Number of retries field, enter a value for the number retries. The default is 0.
From the Delay Between LUs (secs) field, enter a value in seconds. The default is 0 seconds.
If you want try another LU if the current LU is disconnected by the server then check the Enable gateway failure rollover box.