Previous Topic Next topic Print topic


OpenESQL Configuration Utility

Use the OpenESQL Configuration utility to change the default behavior for the SQL(BEHAVIOR) directive option. OpenESQL uses this default only when SQL(BEHAVIOR) is not explicitly specified in one of the following places:

When you specify the SQL(BEHAVIOR) directive in any of these places, the value you specify overrides the default set using the OpenESQL Configuration utility.

Note: The OpenESQL Configuration Utility does not enable you to set the BEHAVIOR directive to either JCL or CICS, both of which are valid settings. If you want to set the BEHAVIOR directive to either of these, be sure to set it in one of the above-referenced places before attempting to compile your application.

You can run this utility, using either its user-interface or command-line implementation (esqlconfig command), on each machine where you have installed Studio Enterprise Edition 6.0, Service Pack 1, Websync 1 or later, to change the default behavior before attempting to compile programs that do not specify the SQL(BEHAVIOR) directive in one or more of the above-referenced places. You need not run the utility again even after installing software upgrades; however, if you need to change the default behavior at any time, you can run the utility to do so as often as necessary.

Using the OpenESQL Configuration utility, you can set the default behavior to one of the following options:

Previous Topic Next topic Print topic