WYSE Settings - Display Communication Page

The default values provided for most options in the Display Communications page are suitable for most users.

Table 56

Setting	Description
Communication Mode	Specifies the way data is transferred between your workstation and the host. Full Duplex : Sent to the host. Half Duplex : Sent to the host and displayed on the screen. Block/Half Block : Displayed on the screen, but not (yet) sent to the host.
Block End	Defines the end-of-line and end-of-block terminator when sending a block of data. US/CR: The line terminator is ASCII US; the block terminator is CR. CRLF/ETX: The line terminator is CR and LF; the block terminator is ETX.
Send Acknowledgement	If enabled, after receiving ENQ or after certain commands are executed, an ASCII ACK code is sent to the host. These commands include page print commands and font load commands.
Send Answerback	If enabled, the answerback message is sent to the host in response to an ASCII ENQ.
Answerback	Specify your answerback string. This string is sent in response to an ENQ from the host. Both Send Acknowledgement and Send Answerback must be enabled. You can use up to 20 characters, including control and special codes. If you want to include the left brace ( { ) as part of your answerback string, it must be enclosed in quotes when typed in the dialog box, "{". The string will appear as typed, but only the left brace will be sent to the host.
Conceal	When selected, the Answerback message is concealed and cannot be redisplayed. To display the Answerback message, you must retype the Answerback message in the edit box.