Previous Topic Next topic Print topic


Setting Run-time Switches

Restriction: These switches are supported for native COBOL only.

You can specify programmable and general run-time switches using the following methods:

In the IDE
Set programmable switch values in the project's application configuration file within the IDE. The values set here are built into your application and are always used as the defaults when the application is run. You can override the defaults when running the application using one of the other following methods.
Using environment variables
Use the environment variables COBSW and OOSW (for switches for object-oriented programs) to set or override the switch values when the application is started.
Note: We recommend that for switches affecting file handling, you do not use COBSW, but edit the file handler configuration file (extfh.cfg) instead.

The following command sets the programmable switches 1 and 4 on, and all the others (2, 3, 5-8) are off by default:

set COBSW=+1+4
On the command line
Specify switches on the command line when you start the application. Switch set here take precedence over those in the environment variable (COBSW).

In the following example, the command loads the program myprog with programmable switches 5 and 7 on and switch 2 off, and all the others (0, 1, 3, 4, 6 and 8) are off by default. Note that switch 7 is turned on, since the last setting of it (that is +7) is the one used.

myprog (-2+5-7+7)

or:

run (-2+5-7+7) myprog.gnt
Note: You must enclose the switches in parentheses.
The following command loads the program myprog with switch T on and switch O off:
myprog (+T-O)
Previous Topic Next topic Print topic