Reflection Desktop Help & HowTo > Terminal Sessions > VT Sessions > Select Terminal Type Dialog Box > Advanced Options Dialog Box for Wyse Terminal Types

Advanced Options Dialog Box for Wyse Terminal Types

Getting there

Open a VT terminal session and then open the Settings dialog box.

The steps depend on your user interface mode.

User Interface Mode	Steps
Ribbon or Reflection Browser	With a session open in Reflection, from the Quick Access Toolbar, click .
TouchUx	Tap the Gear icon and then select Document Settings.

Under Terminal Configuration, click Select Terminal Type.
Under Terminal Type, select a Wyse terminal type.
Under Terminal Settings, click Terminal Setup.

The options are:

Wyse Features

Label lines	The terminal decides how many label lines are visible by how many display rows are requested. Reflection allows you to always have two. If only one label line is visible, use the Shift key to display the second line.
Status line	Select a status line type.

Answerback message

Answerback message	If the host expects an answer in response to an ENQ character, type the answer here.
Insert special characters	Select to allow escape sequences and ASCII control codes in the message (for example, press Enter to include a CR character).
Auto answerback	Select to cause the answerback message to be sent to the host automatically after a communications line connection. You may transmit the answerback message at any time by pressing Alt+F7 (this method of sending the message replaces the VT320 keystroke Ctrl+Break).
Clear	Click to clear the answerback message.
Conceal	Click to replace the message with the word <Concealed>. Once a string is concealed, there is no way to unconceal it; you have to replace the text by typing new text, or click Clear to start again.
Serial device to host	Select to maintain a serial connection to the configured port and send any characters received from this serial connection to the existing host connection. This setting is typically enabled by the host application when it is required.
Configure	Click to select and configure a serial port. The Configure button from the Terminal Setup Advanced Options dialog box is equivalent to the Configure button from the Logging Settings dialog box. You can use the button from either dialog box to configure your serial device port.

Related Topics