Configure Connection Settings Dialog Box

Getting there

Open a 5250 terminal session.

Open the Document Settings dialog box.

The steps depend on your user interface mode.

Ribbon or InfoConnect Browser	With a session open, from the Quick Access Toolbar, click .
TouchUX	With a session open, tap the Gear icon and then select Document Settings.
Classic MDI	With a session open, go to Options > Settings

Under Host Connection, click Configure Connection Settings.

From this dialog box, you can specify the settings for a TN5250 connection.

Connection

Enter Host (or System) Name or IP Address	Identify the host to which you will connect. Type the host name, alias, or numeric IP address. NOTE:Both IPv4 addresses (in the form 127.0.0.1) and IPv6 addresses (in the form 2001:0db8:3c4d:0015:0000:0000:abcd:ef12) are accepted.
Port	Type the host port or socket number that the session should use. This field accepts any number between 0 and 66,535 (default = 23).
Device name	Specify the terminal device name (also called the display name or the workstation ID) that the AS/400 should use for your session. If you leave this box blank, the AS/400 creates a device to use for your session. The device name can be up to ten characters long. You can include any of the following characters as part of the value in the Device name box.
	Character	Usage
	*	Replaced by A, B, C, and so on to create a unique device name. If the entire alphabet is used, the generated device names continue with AA, AB, AC, and so on.
	%	Replaced by P for printer sessions and S for display sessions.
	=	Replaced by 1,2, 3, and so on to create a unique device name.
	&COMPN	Replaced by the local workstation name, left-trimmed, if the generated name exceeds 10 characters.
	&USERN	Replaced by the local user name, left-trimmed, if the generated name exceeds 10 characters.
	+	Specifies right-trimming instead of left-trimming. Use with &COMPN or &USERN. This character can be placed anywhere in the string.
	NOTE: You can use only one string in combination with these characters. If you use separated strings, the second string is dropped. For example, %MyDevice= is valid. However, %My=Device is not valid, and will be treated by the system as if it were &My=. You cannot use both &COMPN and &USERN in the same string. To have InfoConnect generate unique device names automatically based on the special characters described above, the Generate Device Names setting must be enabled. In printer sessions, this setting is off by default.

Options

Automatically connect to the host

Select to establish a host connection as soon as the associated session document is opened.

When connection is terminated	Specify options for reconnecting after any disconnection that is not initiated from InfoConnect.
	Choose	To have InfoConnect
	Reconnect automatically	Attempt to reestablish the connection.
	Prompt for reconnection	Prompt whether to attempt to reestablish the connection. (When No is selected, the session is left open and disconnected.)
	Leave disconnected	Leave the session disconnected with the session open.
	Close session automatically	Close the session.

Model

Model ID

Specify the model of the terminal or device type emulated by this session.