Add Hubs to Gateway Administrator

Hubs are required to support Reflection Gateway Jobs. You must add at least one Hub before you can configure Jobs.

Hubs are not used for Transfer Sites; if you use only Transfer Sites, you can skip this procedure.

Before you begin

Install the Reflection Hub feature on the Hub server.

You will need to know a host name or IP address that can be used by Gateway Administrator to connect to this Hub.

To add a Hub Server to Gateway Administrator

Log on to Gateway Administrator using the default admin account, or any account that has the System setup role enabled.
Go to System > Hubs and click New.
For Reflection Hub server, enter the name or IP address of the Reflection Hub. The correct default listening port is entered automatically. Unless an administrator has modified this port, do not edit this value.

The name and currently configured listening port for the server running the Reflection Gateway Administrator service are entered automatically. In most cases you should leave these as entered.
Click Save and Activate. This tests the connections between the servers and configures certificates that are used by each server for authentication in subsequent connections. (For details, see Hubs Tab.)

NOTE:You can add multiple Hubs to ensure availability of the Reflection Hub service. If you configure connections to more than one Hub, Reflection Gateway uses a round robin schedule to determine which Hub to connect to.