Type the Polling directory of the GetAscii
interface, the Name of sender, the Timeout (in seconds), and the Recipient
of checks.
For additional information, see PageGate Gateway Settings Page.
To confirm that the configuration has been successful, click Check and verify if the pager recipient, Recipient
for checks, receives the test message.
If you receive an
error message, review your PageGate settings. Make sure that the polling directory
is accessible. Verify that PageGate’s GetAscii interface is configured and
points to the correct polling directory. Verify that the sender and recipient
users are registered in the PageGate list of recipients.
If you confirm that a test message has been sent and that the
test recipient has received the message, click Save.