Configure Record Separator Dialog Box
Getting there
-
Open a VT terminal session and then open the Transfer Settings dialog box.
The steps depend on your user interface mode.
User Interface Mode
Steps
Ribbon
On the ribbon, from the group, click the launcher:
Reflection Browser
On the Reflection menu, choose and then . In the Transfer dialog box, click the button.
TouchUx
Tap the Wrench icon and then under , select . In the Transfer dialog box, click the button.
-
From the dialog box, select the WRQ/Reflection protocol.
-
Click the tab.
-
Under , click .
This dialog box applies only to ASCII file transfers using the WRQ/Reflection protocol.
A record separator is a character string that signifies the end of a data stream, or record. Which character string serves as a record separator can vary according to the computer.
- To host
-
Select to remove the record separators listed in the box from the file, and replace them with the record separator appropriate for the host.
By default, the most common record separator for PCs, carriage return/line feed ( CR/LF), is specified.
Select to type the character string you want Reflection to interpret as your PC's record separator. The characters you type on your keyboard will appear in the box.
- From host
-
Select to remove the record separators for the host from the file and replace them with the record separator in the box.
By default, the most common record separator for PCs, carriage return/line feed ( CR/LF), is specified.
Select to type the character string you want Reflection to interpret as your PC's record separator. The characters you type on your keyboard will appear in the box.