SABRE2 Path Configuration Dialog Box
How do I get to this dialog box?
From InfoConnect Manager
-
Select Paths in the left pane, then click Add.
-
Select SABRE2 and click OK.
-
Enter a Path ID and click Configure.
From the Database Editor
-
Under Connection type, select SABRE2.
-
Select an existing path (or, click + to add a new record).
-
Click Configure Path.
Note
To configure and use a SABRE2 path, you must first install and configure third party software (CCSAPI from Sabre).
Addressing
Select one of the following for the address.
| Use fixed address (LNIATA) | Enter the six-digit LNIATA address. This is comprised of two digits each for the line number, interchange address and terminal address. |
| Allocate address from pool | If you use an address pool, either select a preconfigured address pool from the list or click Configure to configure the address pool. |
| SABRE CSAPI Route Name | Specify the name of a route in the csapi.cfg file. |
| ALC configuration (.cnf) file | Specify the full path to the ALC configuration file. |