Advanced Tab (More Settings Telnet Dialog Box)
Getting there
-
Open a VT terminal session.
-
Open the dialog box.
The steps depend on your user interface mode.
Ribbon or InfoConnect Browser
With a session open, from the , click
.TouchUX
With a session open, tap the Gear icon
and then select .Classic MDI
With a session open, go to >
-
Under , click .
-
Under , select .
-
Under , select .
- Under , click the button
The options are:
|
|
Select the maximum number of sessions you want to allow for a Telnet connection. |
|
|
Type a value to send as a backup to the Telnet server if the server requests this information, and doesn't recognize the current value set for . NOTE:During negotiations, some hosts that could successfully connect using your preferred terminal type skip over this value during negotiations and connect using the backup value specified by . To correct this behavior, set to an empty value (""). |
|
|
Select to choose a specific local port for InfoConnect to connect through to communicate with the host. If this option is cleared, InfoConnect will use the next available port. |
|
|
Specify a local port. If this option is set to zero, InfoConnect uses the next available port. |
|
|
A "true" Telnet host expects to see a CrNu (carriage return/null) character sequence to indicate the end of a line sent from a terminal (in this case, InfoConnect). There are some hosts on the Internet that are not true Telnet hosts, and they expect to see a Lf (line feed) character following the Cr at the end of a line. If you're connecting to this type of Telnet host, select this option. |
|
|
(Optional) Type up to 41 characters of descriptive text to provide information about your session. For example, you might include your system location, computer name, or IP address. This features uses the SEND-LOCATION option supported under Telnet connections (RFC779). InfoConnect does not initiate a WILL SEND command unless you activate the option by typing information in this box. |