Print Device Forms Mode

Getting there

  1. Open a printer emulation session.

  2. From the Setup menu, choose View Settings.

This setting specifies how forms are fed into the printer, or the form feed type used for spooled files.

Choose from the following options:

*AUTOCUT (default)

Use when single-cut sheets are fed into the printer automatically (the printer must have the sheet feed attachment).

*CONT

Use when continuous forms are fed automatically by the printer.

*CUT

Use when single-cut sheets are fed manually into the printer.

NOTE:The value for Paper Source 1 overrides the value for Print Device Forms Mode when Host Print Transform is enabled.