If you are running a 5250 printer emulation code, you may see an exception code display in the printer panel Status box. Refer to the following table for more information.
|
Code |
Meaning |
|---|---|
|
10 |
The data stream control is unsupported or unrecognized. |
|
11 |
Printing will occur outside the specified left or right margin. |
|
12 |
An illegal superscript or subscript character was received. |
|
13 |
The data stream control is not supported unless the Bypass Windows print driver in transparent mode check box is selected. |
|
14 |
A graphics character is unprintable. |
|
15 |
The data stream control is not supported while the Bypass Windows print driver in transparent mode check box is selected. |
|
16 |
Printing will occur above or below the specified top or bottom margin. |
|
17 |
A control in the data stream is illegally nested. |
|
20 |
A supported control exists at an invalid position in the data stream. |
|
21 |
An invalid indent level was received or there is no tab stop at the specified indent level. |
|
22 |
No horizontal tab stop setting found. |
|
23 |
The length of a line exceeds the justified right margin or the margin exceeds the page width. |
|
24 |
Backspacing will occur beyond the leftmost physical print position. |
|
25 |
Text will be printed below the bottom of the page. |
|
26 |
Justify control violation. |
|
30 |
Unsupported data stream control. |
|
31 |
A required control parameter is missing. |
|
32 |
An unsupported control parameter has been detected. |
|
40 |
Invalid parameter value in multi-byte control. |