From InfoConnect Manager
Select Paths in the left pane, then click Add.
Select INT1 from the list of path templates and click OK.
To the right of Channel, click Examine Channel (or Configure Channel if you are logged in as an administrator.)
From the Database Editor
Under Connection type, select INT1.
Select an existing path (or, click + to add a new record).
Click the Environment tab in the lower portion of the window. (You must be logged in as an administrator to save changes to this tab.
When you configure an INT1 path, you must specify the environment.
|
Environments |
Specify the $$OPEN name that you will use during terminal emulation to access the host application (up to 12 characters). For example, to access the host application by typing $$OPEN MAPPER during terminal emulation, you would enter MAPPER in this box. |
General
|
Application |
Specify the name of the host application. |
|
Initial transaction |
Specify any initial transaction that is associated with the host application you want to run. For example, to run MAPPER, you transmit the ^ symbol. |
|
Send initial transaction after receiving |
The word or phrase that the PC must send to the host to establish a connection with the host and access a particular host operating mode or application (such as TIP, Demand). |
|
Link to |
Internal connection Predefined path |
|
Connection |
|
|
TSAP |
Specify this only if you're using a Host LAN Controller or a Distributed Communications Processor in IP router mode. |
Authentication
|
Method |
Specify the method of authentication used to access the host:
|