Use this page to view information about the PPT named ppt_name, selected from the PPT (Active) page. You can also change the status of the PPT, and change various parameters of the PPT.
This page mainly provides information about the PPT. To set values for the PPT, use the CICS PPT page.
Click this to save changes you have made to the page and refresh the page.
Shows the name of this PPT. If you click Apply, the message "Update complete" is also displayed when the changes you have made to the PPT have been saved and the PPT updated. Click Refresh to remove this message.
Shows the location and name of the executable file in use. You see an entry in this field only after the executable file has been used.
Shows the current settings that apply to this PPT. You can change any of the settings.
Click this to enable the PPT.
Click this to disable the PPT.
Check this to limit the program to the Distributed Program Link API subset of commands; there is no terminal control, BMS, and so on.
Check this to allow the use of the CICS Execution Diagnostic Facility, which enables debugging at the CICS command level.
Check this to indicate that the program resides in the application server's program cache after it has been loaded.
Click this to indicate that the program language is COBOL.
Click this to indicate that the program language is PL/I.
Click this to indicate that the program language is C.
Click this to indicate that the program language is Assembler.
Check this to indicate that load requests are ignored if the program is already in storage. Leave unchecked to indicate that a fresh copy of the program is loaded every time a load request for the program is issued.
Shows whether the PPT is associated with a program or data.
Shows the size of the module and the minimum size of the Commarea.
Shows:
Click this to create and view a dump of the DCT.