COBRT198 Load failure (Fatal)

The system cannot load a program module or, in a multi-threading program, start a new thread.

A CALL statement has failed because:

In the case of a DLL, the specified entry point does not exist in the file
In the case of an .int or .gnt file, the file has been corrupted
In the case of a call of the form $PROG, name mapping has failed
In the case of a call-by-number library routine (CALL data-name, where data-name is a pic x with value greater than x'80'), the routine does not exist

Any call or attempt to start a thread can fail where internal structures have been corrupted; for example, by a protection violation.

A statement of the form SET PROCEDURE POINTER TO ENTRY entry-point has failed because the entry point cannot be found on disk or in the current run-unit.

The Entry Point Mapping facility has found a program on disk with the same name as an alias definition. Whether or not this condition results in a COBRT198 error depends on the setting of the entry_point_mapper_alias_exists_error tunable.

Rarely, this error can be caused by a CALL statement failing because of insufficient available memory or because the run-time system version is too old.

Resolution:

Check that the target of your call exists and has not been corrupted.

Test that a procedure pointer is valid before using it by including code of the form:

set bad-pointer to entry 'just-not-there-ever'...set procedure-pointer to entry 'myentrypoint'if procedure-pointer = bad-pointer display errorend-if