Single mode reconnect for CICS

In this configuration, each time a transaction is about to execute, an xa-ping is attempted. If this fails an xa-close and xa-open followed by an xa-ping are executed. If these fail, an error message is sent to the console indicating that the connection to the Resource Manager (RM) has been lost. The RM is not disabled.

On each attempt to execute a transaction, the same processing takes place until the connection to the RM is re-established. If the connection to the target RM is lost and the transaction requires the target RM, then the application program determines if action to recover the error is required, such as ABEND or rollback, or to display a message to the console. If the RM is not disabled, all XA error messages are displayed in the console. When the connection is re-established, a message is displayed in the console.

Configures the XA reconnect process to operate in a single-attempt mode.

Syntax

ES_XA_RECONNECT=Y,wait-time[,retry_count]

Parameters

Y

Enables the reconnect process.

wait-time

The number of seconds to delay before triggering the XA recovery transaction after a two-phase commit failure and between each reschedule of the XA recovery transaction if the syncpoint phase 2 returns an RC 04. Maximum is 300.

retry_count

The number of recovery retries to attempt when the XA commit or rollback executed by the XA recovery transaction returns an RC-04. Default is 5.

Default

Not set. XA reconnect operates in multi-attempt mode.

Comments

In case of failure, the following messages are sent to the console:

CASXO0054W XA recovery error RC=4 on commit in-doubt transaction RM: RM01 RC:  00004 XID: MF_CAS  DEMOMYREG           000000***********000010000000**        0000

When the maximum number of retries is reached, the following message is sent to the console:

CASXO0055S XA MAX recovery attempts, manually commit in-doubt transaction RM: RM01 RC:  00004 XID: MF_CAS  DEMOMYREG       000000***********000010000000**        0000

Example

ES_XA_RECONNECT=Y,120,4