Configuration Targets
Targets are not required for all command types, only for those that run on remote servers. Before you can add a target to a Configuration (explained here), you first need to define it as described in Specifying Targets.
Use controls on the Configurations Targets tab to add, edit, or remove targets in a configuration.
Note: If you plan to add remote targets to a configuration, you need host information for the remote servers and login credentials if authentication is required.
Adding a Target to a Configuration
Targets are applicable to any commands that you want to send to a remote server.
-
Click Add to bring up the Connectors Selector dialog.
-
Navigate to and click (check mark) the target you want to add, and click OK.
Editing Targets in a Configuration
-
Select the target you want to edit and click Edit.
-
This provides a shortcut into the SmartConnector Configuration Editor for the selected connector or target. (See Configuring the SmartConnector, and also the SmartConnector User’s Guide.)
Removing Commands from a Configuration
On the Configurations Contexts tab, select a target in the list and click Remove.